21
ASSEMBLY
1. Wheels assembly kit (optional). Position the support bracket of the wheels
(N) under the base (A). Coincide with the holes, insert the 4 bolts (?) and screw
them in with the 4 nuts as in Fig.1.
2. Join the base (N) with the central support (F) using the lower rods (I). Fasten
everything with the screws (AA). For each shaft, 3 screws are needed to fasten
the base (N) and 2 screws to fasten the central support (F) for each rod. The
correct position of the central support (F) is obtained by positioning the base
surface at the same height as the lower rods (I), and the magnets must be kept
on the opposite side of the fastening holes of the wheels kit (M) as in Fig. 2.
3. Connect the upper rods (C) to the lower rods (I) resting one on the other and
fastening them to the lower part with 2 screws (AA) per rod. Insert the burner
(B) coinciding with the fastening holes and fasten it with the 8 screws (AA) as
in Fig. 3.
4. Position the switch on unit (G) under the central support (F), align the holes
and fasten with 4 screws (AA) as in Fig.4
5. Fasten the reflective panel (A) to the burner (B) coinciding with the fastening
holes and fasten it with the 3 screws (AA) as in Fig. 5.
6. Insert the rubber ring (GG) on the glass tube (E) as in Fig. 6.
7. Carefully position the glass tube (E) in the central burner hole (B). Always
move with caution and insert the glass tube (E) in the central support hole (F),
paying attention to correctly position the rubber ring, as in Fig.6.
8. Insert the grid guards (D) on the frame of the pyramid, with its hooks coin-
ciding with the holes placed on the upper rods (C).
To fasten the safety grids (D), take the 4 fastening brackets (II), position them
at the centre of each burner (B) and screw in with 4 screws (AA), as in Fig.7-7A
9. Position the 3 fixed panels (H) on the three sides of the pyramid (excluding
the commands side) and after the holes coincide fasten with 12 (AA) screws.
10. Place the chain (NN) on the bracket (HH) by inserting the coupling ring in
the hole prepared for the bracket (HH). Position the handle (FF) on the front
opening panel (L), coinciding the holes and block by screwing in the 2 screws
(DD) after correctly positioning the 2 washers (EE). The chain with the bracket
must be inside the structure as in Fig.9.
11. The tabs placed on the lower part of the front opening panel (L) must be
inserted in the C shaped holes overturned on the base (M). Insert the ring of
the chain (NN) in the hook of the switch on unit (G) and close the panel. Closure
