20
21
Internal honeycomb panel
Internal honeycomb panel
Wash with running water
Filter
ral mode
(the air speed lifts or lowers
automatically) and night mode (alter-
nating the air lowest air speed, suita-
ble for night).
Timer (Timer key L5/A5): activates or
bypasses the timer (max 12 hours with
intervals of 1 hour), which on expiry
shuts-off the appliance. If the timer is
not activated, the appliance works non-
stop until it is manually switched off.
Cooling (L6 or A6) before using the co-
oling function, fill the water tank to the
maximum level indicated. It is possible
to add a bit of ice or add two ice con-
tainers (M) in the water tank after they
were frozen.
CLEANING AND MAINTENANCE
After long use, the filter and the ho-
neycomb panel could get clogged by
dust, which would considerably influen-
ce the performance of the machine.
If the water is not changed for a long
time, mildew and fungus can form. The
following cleaning procedure is recom-
mended:
1. Having removed the plug from the
machine, remove the screw from the
rear compartment and remove the filter
and the honeycomb panel.
2. Wash the filter with a delicate deter-
gent solution and lukewarm water, then
rinse with clean water.
3. Wash the honeycomb panel in clean
water. Use the soft brush for cleaning.
4. Put the filter and the honeycomb pa-
nel in the original position and fasten
the screw.
5. The water tank must be cleaned if it
is clogged with dirt after long use. The
cleaning procedure is as follows: firstly,
unscrew the filter screw in the com-
partment and pull the honeycomb panel
out. Detach and remove the water tank,
then clean with a brush. Continue to
brush until the water tank is clean.
PARTICULAR WARNINGS
1 Use the correct power supply (220 -
240V~ 50Hz).
2. After topping up the water, do not
move the machine if the water exits.
3.Do not put heavy objects over the air
cooling device. Keep the air output free.
4.The suitable ambient temperature is
between 5°C and 40°C. When the am-
bient temperature is high, change the
water more frequently to prevent mil-
dew formation. If you use the machine
as a humidifier during the cold season
(under 0°C), ensure you empty and dry
the machine body after use to avoid fre-
ezing the water.
5. Avoid the LED control panel being ex-
posed to water or water sprays. Do not
use corrosive or solvent detergents.
6. Empty the water tank before moving
the unit.
7. Before use, dry the entire machine,
the honeycomb panel, the filter and the
body to avoid any damage caused by
water.
8. Disconnect the machine when not in
use. Do not use the cooling function if in
a closed and damp space.
9. Do not put your finger or other objects
in the slot when the machine is working.
10. Do not use the machine if the po-
wer cable or plug are damaged. These
must be replaced or repaired by quali-
fied staff.
11. Pay attention to children when they
are near the machine when on.
12. Pay attention there is water inside
the tank before using the cooling fun-
ction.
13. Do not activate the cooling function
before topping up the water, to avoid
damaging the water pump.
14. Keep the machine out of children’s
reach when there is no adult supervi-
sion.
15. Detach the plug when you add the
water or during cleaning of the applian-
ce.
