10
©2012 Johnson Level & Tool
Beam Configurations
Unlock the laser and the laser is on, the
configuration of the laser beams is as
follows:
Press the button once and the vertical line
is off, the configuration of the laser beams is
as follows:
Press the button once again and the
horizontal lines are off and the vertical line
is on, the configuration of the laser beams is
as follows:
Press the button once again, both
horizontal lines and the vertical line will be
off, there are no laser beams.
Press the button, the laser will produce
three laser dots (front, up and down dot).
Press the button again, the laser will switch to line laser mode.
The button controls switching between the laser line and
laser dot modes.
6222H_Manuals 10/2/12 8:54 AM Page 10
