©2017 Johnson Level & Tool
7
Using the Product
1. Press the power button to power on the tool, and it will emit two
laser beams.
2. Position the laser so that it is appropriate to your application
needs. Follow a reference line or, if necessary, align the laser
beams with reference points.
3. Use the laser beams as the new reference lines, since they can be
seen over mastic or floor coatings.
4. To power off the tool, press the power button.
Establishing Common Angles
1. Mark the point on the floor where the laser beams would intersect
(Point A).
2. Using the angle scale as a guide, mark the point on the floor that
corresponds to the angle you want to establish (Point B).
3. Rotate the laser so that the 0° angle scale is on Point B, and
make sure that the laser beams still intersect at Point A.
Laying Square Tiles
1. Position the Tiling Laser in a corner so that the 0° laser line runs
parallel to a wall and the T-edge of the Tiling Laser faces against
the wall.
2. Lay the first square tile so that any right-angled side of the tile is
seated flush on the 0° and 90° laser line.
1835i-English_Manuals 3/15/17 11:55 AM Page 7