27
S1
S3
S2
T
M
M
S
T
Fig. 8
Fig. 9
S
S
Z
T
G
Fig. 10
Fig. 11
DD
1
2
TABLE FAN ASSEMBLY
7 Assemble the tubes of the base (S) by inserting them into each other, position the
central tube (S1) with the holes facing downwards and insert the tube (S2) on its right
side S2 is the tube with the holes to fix the switch coupling support (Z), and tighten
with the screw (T).
Insert the tube (S3) on the left side and tighten with the screw (T). Fig. 8
8 Using the screw and nut (M) fix the motor body to the base (S) Fig. 9.
For the assembly of the motor body (E), the rear grill (D), the fan (B) and the front grill
(A) see points 345. Fig. 345
It is possible to fix the switch coupling support (Z) on the fan base (S).
Align the holes in the support (Z) with those in the base (S) with its tab facing the back
of the device and screw with the 2 screws (T). Fig. 1011 For correct inclination of the
motor unit (E) on the base (S), make sure that the tongue (DD) of the motor body (E) is
housed in the seat (1) of the base (S). Fig. 11.
Summary of Contents for 3X
