20
Components
A Front grille
B Fan
C Rear grille locking ring
D Rear grille
E Motor body
F Swing selector
G Speed selector
H Cable with plug
I Extendable tube
J Height adjustment ring
K Base tube
L Base screw cover
N Base
O Screws and nuts for base fixing
V Screw with nut for fixing grids
W Motor locking screw
X Fan locking screw
Z Switch hook support
AA Switch holder screws
BB Holes for fixing grids
CC Crankshaft
Remove the appliance parts from the
package and dispose of the packaging
components according to the law. Check
that the product is intact and that all
components are present. In the event of
obvious anomalies or transport damage,
do not use the appliance, but contact the
retailer or an authorized service center.
FAN ASSEMBLY A FLOOR LAMP
1- Insert the base tube (K) into the hole
in the base (N). Make the reference holes
coincide, insert the 4 screws (O), position
the nuts (O) and tighten firmly. Unscrew
the ring nut (J) of the base tube (K) and
insert the base screw cover (L), position it
correctly and screw the ring nut (J) back
onto the base tube (K). after placing it at
the desired height. (Fig. 1- 2)
2- At the top of the extendable tube (I) po-
sition the motor body (E) fixing it with the
reference screw (W). (Fig. 2)
3- Unscrew the ring nut (C). Place the rear
grill (D) on the motor body (E) making sure
that the handle is facing upwards and the
small hole (BB) downwards.
Respect the correct insertion, and lock by
screwing the ring nut (C). (Fig. 3)
4- Fix the fan (B) on the motor shaft (CC)
with the screw (X).
Attention: the screw (X) must be screwed
in correspondence with the flat seat obtai-
ned on the motor shaft (CC) and turned
towards the inside of the device. (Fig. 4)
5- Place the front grille (A) on the rear gril-
le (D), aligning the small holes (BB) located
in the lower part of the grills.
Insert the screw (V) into the holes (BB) by
screwing it to its nut (V) and close with the
grille locking clips. (Fig 5)
L
O
N
K
O
Fig. 1
Fig. 2
