Aug-22
o
Check and clean laser lenses and mirrors.
o
Check laser alignment. (see laser users manual on how to check and adjust laser beam alignment)
•
The engraving is too deep.
o
Laser power setting and/or resolution may need to be decreased.
o
Laser speed setting may need to be increased.
•
The engraved area is charring/melting.
o
Laser power setting and/or resolution may need to be decreased.
o
Laser speed setting may need to be increased.
•
The edges along the laser cut line are curling.
o
Laser power setting may need to be decreased.
o
Laser speed setting may need to be increased.
o
Make sure the laser cutting ("honeycomb") grid is inserted to set the product up off of the solid
metal laser bed.
o
Make sure air assist is running when cutting.
To order more of this product, see similar products and much more, please visit jpplus.com.
For additional product support and troubleshooting, please contact JPPlus Advanced Support Team:
•
Phone: 419-500-4877
•
Email: [email protected]
•
Schedule an appointment: https://jpplusadvancedsupport.setmore.com/
