Johnson Controls ZFR1812, Installation Instructions Manual

Page: 6 / 13

ZFR1812 Wall Mount Wireless Field Bus Router Installation Instructions
6
For further information on how to set up a field
controller to work with the ZFR1812 Router, refer to the
following documents:
• FAC3611 Advanced Application Field Equipment
Controller Installation Instructions (Part No. 24-
10143-470)
• FEC16 Field Equipment Controller Installation
Instructions (Part No. 24-10143-136)
• FEC26 Field Equipment Controller Installation
Instructions (Part No. 24-10143-144)
• IOM17 and IOM27 Input/Output Modules
Installation Instructions (Part No. 24-1044-76)
• IOM37 Input/Output Module Installation
Instructions (Part No. 24-1044-84)
• IOM47 Input/Output Module Installation
Instructions (Part No. 24-1044-92)
• VMA16 Series Variable Air Volume Controllers
Installation Instructions (Part No. 24-10143-20)
Table 2: Connecting the ZFR1812 Router to a Field Controller
Field
Controller
Model Plug the ZFR1812 Router
Connector Cable into the
Following Jack on the Field
Controller: Connection Points for the
Bluetooth® CVT
Commissioning Interface
and Other SA Bus Products
1
Use This
Communications Port
between WEFC and
Wired IOMs, WRZ
Sensors, or VFDs:
FAC26 FC Bus RJ-12 Jack SA Bus RJ-12 Jack SA Bus Terminals
FAC36 FC Bus RJ-12 Jack SA Bus RJ-12 Jack SA Bus Terminals
FEC16 FC Bus RJ-12 Jack SA Bus RJ-12 Jack SA Bus Terminals
FEC26 FC Bus RJ-12 Jack SA Bus RJ-12 Jack SA Bus Terminals
IOM17
2
,
3 SA/FC Bus RJ-12 Jack Not available in wireless mode.
Use CCT with ZFR Dongle. N/A
IOM27
2
,
3 SA/FC Bus RJ-12 Jack Not available in wireless mode.
Use CCT with ZFR Dongle. N/A
IOM37
2
,
3 SA/FC Bus RJ-12 Jack Not available in wireless mode.
Use CCT with ZFR Dongle. N/A
IOM47
2
,
3 SA/FC Bus RJ-12 Jack Not available in wireless mode.
Use CCT with ZFR Dongle. N/A
VMA1615/30 FC Bus RJ-12 Jack SA Bus RJ-12 Jack SA Bus Terminals
1. SA Bus Products include the DIS1710 Local Controller Display, the MS-BTCVT-1 Wireless
Commissioning Converter, and the NS Series (hard-wired) Network Sensors, Balancing Sensors, and
Discharge Air Temperature Sensors.
2. IOMs cannot be used in wireless mode to extend the IO of a field controller. You must always hardwire
IOMs to their host field controller.
3. Do not connect any device to the SA Bus/FC Bus terminal block when using the IOM with a ZFR1812.
Figure 7: Pin Number Assignments for
RJ-12 Jack
Power
(15 VDC)
SA or FC Bus +
SA or FC Bus
-
Bus and Power Common
Power (15 VDC)
Sensor, SA Bus, or FC Bus Port
(RJ-12 Modular Jack)
Bus and Power Common
FI
G
:R
J_
p
in
o
u
t
2
3
4
5
6
1