KT-MOD-IO16 RS-485 Input/Output Module Installation Guide
21
Mounting the KT-MOD-IO16
Mount the KT-MOD-IO16 in a compatible KT-MOD-CAB or KT-400-CAB
cabinet. Alternatively, mount the KT-MOD-IO16 in a dry and secure location.
To mount the KT-MOD-IO16 in a compatible cabinet, complete the following
steps:
1. Insert the four plastic standoffs through the mounting holes of the KT-MOD-
IO16.
2. Secure the cabinet to the wall in your desired location. Use the appropriate
wall anchors to secure the cabinet to drywall, plaster, concrete, brick, or
other surfaces.
3. Affix the module plastic standoffs to secure the module to the cabinet.
Installing and wiring the KT-MOD-IO16
To install and wire the KT-MOD-IO16, consider the following guidelines:
Wiring regulations
All cables must comply with the following regulations:
• National Electrical Code
• NFPA 70
• Local electrical codes
• Canadian Electric Code C22.1. This applies to installations in Canada.
• BSI Standard BS7671, latest edition. This applies to installations in the
United Kingdom.
Wiring an SPI module
Kantech does not supply a cable with the KT-MOD-IO16. To wire an SPI
module to the KT-MOD-IO16, use the KT-MOD-SPI-16 cable that is supplied
with the SPI module. Alternatively, use another 6 conductor cable. Cut the
cable at the header end and strip the wires.
Wiring the KT-MOD-IO16
To wire the KT-MOD-IO16, consider the following guidelines:
Summary of Contents for Tyco Kantech KT-MOD-IO16
Page 25: ......
Page 26: ...www kantech com 2019 Johnson Controls All rights reserved...