Security
Passing the RJ45 connector through the grommet
(continued)
Figure 8
Warnings
1.
Before you power up the camera; please ensure that all
packaging has been removed, including packaging located
inside the bubble assembly.
2. Installation and service should be performed only by qualified and
experienced technicians and comply with all local codes and rules to
maintain your warranty.
3. Wipe the camera with a dry soft cloth. For tough stains, slightly apply
with diluted neutral detergent and wipe with a dry soft cloth.
4. Do not apply benzene or thinner to the camera, which may cause
the surface of the unit to be melted or lens to be fogged.
5. To meet EU EMC immunity requirements for security equipment the
mains power for equipment powering this unit should be backed up
by an uninterruptible power supply.
6. When the camera is powered up and not attached to a mount, or
unsupported mounts, or if the camera is loose in / on a mount then
this may result in motor calibration failure or camera vibration. Motor
calibration runs when the camera boots up.
7. Avoid operating or storing the unit in the following locations:
a. Near fluorescent lamps or objects with reflections.
b. Under unstable or flickering light sources.
© 2022 Johnson Controls. All rights reserved. JOHNSON CONTROLS,
TYCO and ILLUSTRA are trademarks and/or registered trademarks.
Unauthorized use is strictly prohibited.
