Security
Mounting the camera to a wall or ceiling (continued)
8. To power up the camera:
Connect an AC24V or 12V DC power supply to the power
connector on the camera cable.
OR
Connect a shielded PoE cable to the ethernet / PoE slot on the
camera cable.
Adjusting the sun shield
1. Loosen the thumb-screw (3) (Figure 1) to move the sun shield
cover forward and backward over the camera body (6) (Figure 1).
Note:
You must securely lock the thumb screw to ensure that the
sun shield cover holds the modified position.
Adjusting the camera position
1. Use the L-key hexagonal wrench to:
i. Unlock the pan screw (Figure 5) and pan the camera field of
view up to 360 degrees.
ii. Unlock the tilt screw (Figure 5) to tilt the camera body up to 90
degrees.
iii. Unlock the rotate screw (Figure 5) and rotate the camera body
up to 360 degrees.
Note:
You must securely lock each screw to ensure that the camera
holds the modified position.
Figure 5: Pan, tilt and rotate screws
Figure 5
Warnings
If the product does not work properly, please contact your dealer
or the nearest service centre. Never attempt to disassemble the
camera yourself. (We shall not be responsible for any problems
caused by unauthorized repair or maintenance.)
In the use of the product, you must be strict compliance with the
electrical safety regulations of the nation and region. When the
product is mounted on wall or ceiling, the device shall be firmly
fixed.
Do not allow water or liquid intrusion into the camera.
Do not use camera beyond specified voltage range.
Do not drop the camera or subject it to physical shock.
Avoid touching the camera lens.
If cleaning is necessary, please use clean cloth to wipe it gently.
Do not aim the camera at the sun or extra bright place.
Do not place the camera in extremely hot, cold (the operating
temperature shall be -
30˚C~60˚C), dusty or damp locations, and
do not expose it to high electromagnetic radiation.
To avoid heat accumulation, good ventilation is required for
operating environment.
© 2021 Johnson Controls. All rights reserved.
JOHNSON CONTROLS, TYCO, and HOLIS are trademarks and/or
registered trademarks. Unauthorized use is strictly prohibited.
