Engineering manual - UniSAB III 1.10.8
001930 en 2021.06
273/346
UniSAB III (boot) and communication set-up
8. UniSAB III (boot) and communication set-up
8.1
Introduction
Sections 8.2 to 8.4 describe the boot set-up menus in UniSAB III. In the boot menus you can set up
Ethernet communication and contrast, you can upload and download software and you can find informa-
tion about internal and external flash memory. The boot loader in UniSAB III is equivalent to the BIOS in
a PC.
Section 8.5 contains a communication overview and instructions on how to configure the UniSAB III
ports for Ethernet, RS485/Danbus and Profibus/DP.
Section 8.6 discusses how to use a PC browser to connect to UniSAB III. You can upload and download
software with a normal browser.
Section 8.7 describes the PC tool for remote HMI control and supervision UniHMI, and the software sim-
ulator tool UniSim.
8.2
Enter boot loader
There are two methods of entering the UniSAB III boot loader menu system:
1.
Power off UniSAB III and power it on again while pressing the
and
keys for 5-10 seconds.
2.
Make a software reset by pressing at the same time the three keys
,
and
. While Uni-
SAB III is resetting, press
and
for 5-10 seconds.
The entry picture for the boot loader menu is shown below. It shows UniSAB III software information and
three menu options:
1.
/Update - of controller software, languages and configuration.
2.
/Info - about flash/file system, Ethernet and contrast setting.
3.
/Exit - to exit the boot loader and start up the UniSAB III controller software.
8.3
Update
Press
/Update to update UniSAB III controller software, language and configuration from the SD flash
card.
If you have inserted an SD card with a valid software path in the card socket on top of the controller mod-
ule, the picture below will appear. It shows the software information for the inserted SD card.
F2
F3
F4
F1
F2
F4
F1
Summary of Contents for SABROE Unisab III Control
Page 1: ...UniSAB III control Version 1 10 8 Engineering manual EN...
Page 2: ......
Page 347: ......