Johnson Controls PENN ACT2, Technical Bulletin

Page: 62 / 116

Maestro Software
62
Unit #3 Generic I/O
Setp:
Stat:
Inputs Outputs Schedules A-Out Usage
Next
Prev
#1
Undo
minutes
0
Timed for
Normal
Override
On
Off
Phase Protect
Sec
Water Heater Te
Sec
20
Water Heater
#3
Control input:
Output name:
Output board: OFF Energize:
6 Pt.
0
Schedule number:
20
112
Normal
Setpoints Value Delay Units
114
On:
Off:
Sec
Sec
0
0
0
Alternate
0
On:
Off:
Output Name: This box can be used to define a
unique name for the output at the board and point
defined below. Output names can be up to
15 characters long.
Output Board and Pt.: This defines the relay that
this output activates.
Energize: This parameter defines whether the
relay will be energized at the On or Off setpoint. In
this example, the Off setpoint (114) will energize
the relay. This also defines the relay failure status.
In this example, the relay will fail de-energized.
Control Input: This provides an association
between a previously defined input and this output.
Schedule Number: This allows the
output to be associated with a schedule.
Setpoints: This defines the value from the
associated sensor that will trigger this output.
The alternate setpoint is used with the schedule.
Phase Protect: This box should be
checked if phase protection is desired for
this output. When phase proteced,
detection of a phase protection fault will
automatically turn the output off.
Override: The On and Off check boxes are
used to override this output either on or off
and to time the override if desired.
Figure 57: Output Parameters