User Manual: NEO System
12
Rev.0.3
2.2.7 Zone Selection Window
In the zone selection window, choose a
zone/zones to make a selection. Choosing a
zone that has already been selected will
unselect it. When the zone is selected, the
button will show a band. There may be
zones that are not displayed on screen, to
scroll through the zone selection window,
use the scroll controls, located at the right
side of the screen. On the right side of the
window, the scroll bar indicates the current
position in the window (see 2.2.6).
Once the selection has been made, press
the "OK" control to confirm navigation,
pressing the "BACK" button will clear the
selection. If no zone is selected and "OK" is pressed, the equipment / system will perform an
automatic selection of all zones.
In each zone depicted on screen will be an indication of its state. It will be identified as follows:
a)
Zone in State of Emergency
Red box on the left side of the zone button
(zone 1 in Figure 4).
b)
Selected Zone
Selection band in the right side (Zones 1, 2, 3, 4 and 7 in Figure 4).
c)
Zone Indicating Fault
Yellow rectangle on the left side of the zone button. (Zone 4 in Figure 4).
d)
Zone Not Selected
Zone not selected (Zones 5 and 6 in
). Zone 8 cannot be selected by default once
disarmed (see 3.4).
e)
Disarmed Zone
Disabled zone. Yellow band on the right side. The button will be a dark-colored area (Zone
8 in Figure 4).
2.3 User Profiles – Access Level and Passcodes
The access levels define the different user profiles that can operate the equipment / system.
Each of the access levels provides permissions to different menu items, level 1 having the
lowest, and level 3 the highest number of options available.
To access a specific level of access, the user must pass security. Once done, the user can
navigate the options until returning to the home screen, or if no action has been performed for
more than 90 seconds.
Figure 4 - Zone Selection Window
