LN Series LN-VSTAT and LN-PSTAT Sensors Installation Instructions
3
Installation
1.
Unscrew the security screw on the bottom of the
casing (Figure 2).
2.
Open the cover by pulling the bottom side of the
casing outwards. Flip printed circuit board to
access mounting hole.
3.
Pull cables 6 in. out of the wall and insert them in
the central hole of the base.
4.
Align the base and mark the location of the two
mounting holes on the wall. Ensure the correct side
of the base is facing upwards.
5.
Remove the device and drill holes, if necessary.
6.
Install anchors into the wall, if necessary.
7.
Ensure the mounting surface is flat and clean.
8.
Insert screws in mounting holes of the base. Do not
overtighten the screws.
9.
Strip each wire 1/4 in.
10. Gently push excess wiring back into the wall.
11. Flip the printed circuit board back into place.
12. .Flip down the front cover verify it clips tightly into
place.
13. Install the security screw (Figure 3).
F
IG
:m
n
tn
g
_bs
Figure 2: Mounting the LN-VSTAT and
LN-PSTAT sensors
Figure 3: LN-VSTAT and LN-PSTAT Sensors
Security Screw