CONNECT THE IQ WiFi 6
STEP
3
POWER UP THE IQ WiFi 6
STEP
1
This is a quick guide for experienced installers only. Refer to
STEP
2
CONNECT TO THE MODEM OR EXISTING NETWORK
1. Plug the barrel jack end of the
power supply into the “DC-IN” port.
Do not plug in the power supply
into outlet until step 3.
2. Connect the provided ethernet
cable into the “WAN” port.
Connect the opposite end of the provided
ethernet cable into the “ETHERNET” port on the
modem*.
Plug in your power supply to
the wall outlet. Router takes
up to 4 minutes to power up,
the power LED will stop
flashing when ready.
* Note: when powered for the
first time and connected to
internet, LED’s may flash for up
to 5 minutes indicating an auto
update.
*Note: for parallel installs plug the
ethernet cable into an available port
on the customer’s existing router (see
additional considerations)
STEP
4
ADD ALL AGENTS
1. Power up an additional IQ WiFi 6 (see
step 3).
2. Using the supplied ethernet cable,
connect one end into the LAN port of the
Controller
3.Connect the opposite end of the same
ethernet cable into the LAN port of the
Agent.
Note: No additional button press or manual
configuration needed. LET PROCESS
FINISH, COULD TAKE UP TO 10 MINUTES
to auto configure.
MODEM/ROUTER
3
1
2
Controller
Agent
2
3
