If you are experiencing difficulty syncing the controller and the agent, we recommend that you move the agent into the same room as the controller
during the sync. Then move the agent to a different location.
To sync the controller and the agent:
1.
Place the agent in the same room as the IQ WiFi 6. Use this agent location only during the sync process.
2.
Connect the agent to a power source.
3.
Wait for the agent power LED to light solid GREEN.
4.
Press the WPS button on the controller and then within two minutes, press the WPS button on the agent.
5.
Wait for the agent internet LED to light solid GREEN. The agent WiFi LED will slowly blink GREEN when communicating.
6.
Move the agent to a new location and connect the agent to a power source.
7.
At the new location, check the agent power LED and make sure it is solid GREEN.
If agent is not preforming well, check the WAN LED to verify that it is not flashing for 30 seconds. This will indicate that the signal is strong. If
flashing briefly once every 30 seconds, the signal is good but not ideal. If it flashes twice every 30 seconds it is just ok. If it is off, there is no
connection.
JOHNSON CONTROLS CONFIDENTIAL AND PROPRIETARY
PAGE
OF
39
55
CONTROLLER AND AGENTS DO NOT SYNC
Summary of Contents for IQ WiFi 6
