Johnson Controls IFC-3030, Programming Manual

Page: 62 / 156

62 IFC-3030 Programming Manual — P/N 52025:C 08/05/2005
Program Autoprogram Menu
Display
This screen will display either the SLC device address or the panel circuit module address when a
previously installed/programmed point does not respond during a subsequent Autoprogram.
Soft Keys
YES
: Press to delete the point information from the panel’s database.
NO
: Press to leave the point information in the panel’s database.
Figure 3.53 Autoprogram Confirmation Screen (Mismatched Point)
Display
The
O L D
field contains the information currently in the panel’s programming database. The
N E W
field contains the information found during autoprogramming. The fields contain the FlashScan
Type ID codes if the device is FlashScan, or they will contain the device type if CLIP.
Soft Keys
YES
: Press this soft key to accept the new device type.
EDIT
: This soft key will appear only when SLC devices are mismatched. It will not appear for
panel modules. Press it to advance to the point programming screen for this point.
NO
: Press if the new information should not be installed over the existing information in the
database.
A U T O P R O G R A M C O N F I R M A T I O N
M I S M A T C H E D M O D U L E F O U N D A T P X X
O L D : C O N T R O L - I C M
N E W : C O N T R O L - C R M
A C C E P T C H A N G E S ?
Y E S N O
B A C K
EDIT
will appear here when the
mismatched point is an SLC device