Johnson Controls IFC-3030, Programming Manual

Page: 141 / 156

IFC-3030 Programming Manual — P/N 52025:C 08/05/2005 141
Appendix I: Local Settings
The panel programming
LOCAL SETTING
choices, available through the Panel Settings (2) screen
(refer to page 22) are described below. The Local Settings screen (Refer to Figure I.1) allows
scrolling through the available choices by pressing the soft key. Choices are Chicago, Singapore, or
Default (no special local settings).
Figure I.1 Local Settings Screen
I.1 Singapore
The
LOCAL SETTING
choice of
SINGAPORE
:
• Does not allow the disabling of a bell circuit either locally or via the network.
• Does not turn ON the System Trouble LED or the System Trouble relay for disabled points.
• Does not turn ON the System Trouble LED, the System Trouble relay, or the piezo when
Drill is initiated.
• Turns ON keypad LEDs, PCB LEDs, Panel Circuit LEDs, and all ACM-24/48 LEDs during
Lamp Test.
• Requires the user to initiate the start of the application when the panel boots/reboots. The
CPU Failure LED will be ON until the user initiates startup. (Refer to Figure I.2.)
Figure I.2 Singapore Application Initiation
L O C A L S E T T I N G S
L O C A L S E T T I N G S : S I N G A P O R E
T R O U B L E
L O A D I N G . . N O S E R V I C E
L A K E V I E W G E N E R A L H O S P I T A L
N 0 8 3
B O O T L O A D E R
1 1 : 5 8 : 4 5 A W E D A U G 2 5 , 2 0 0 4
C P U H A S R E B O O T E D
C O N T I N U E A B O R T
User should select CONTINUE
to initiate applications.
User should select ABORT to
abort applications.