Commissioning Controllers
You commission FX-PCG controllers with the FX-PCT
software, either via a Bluetooth
®
Wireless Commissioning
Converter, a ZigBee
®
wireless dongle, or in BACnet
Router mode when connected to a Facility Explorer
Supervisory Controller. Refer to the Controller Tool
Help
(LIT-12011147)
for detailed information on commissioning
controllers.
Troubleshooting Controllers
Observe the Status LEDs on the front of the controller
and see
to troubleshoot the controller. To
troubleshoot an integral or local controller display, refer
to the
FX-DIS1710 Local Controller Display Technical
Bulletin (LIT-12011666)
.
Table 8: Status LEDs and Descriptions of LED States
Description of LED States
Normal LED
State
LED Color
LED Label
Off Steady = No Supply Power or the controller’s polyswitch/resettable fuse
is open. Check Output wiring for short circuits and cycle power to controller.
On Steady = Power Connected
On Steady
Green
POWER
Off Steady = No Faults
On Steady = Device Fault; no application loaded; Main Code download
required, if controller is in Boot mode, or a firmware mismatch exists between
the FX-PCG and the FX-ZFR1811 Wireless Field Bus Router.
Blink - 2 Hz = Download or Startup in progress, not ready for normal operation
Off Steady
Red
FAULT
Blink - 2 Hz = Data Transmission (normal communication)
Off Steady = No Data Transmission (N/A - auto baud not supported)
On Steady = Communication lost, waiting to join communication ring
Blink - 2 Hz
Green
SA BUS
Blink - 2 Hz = Data Transmission (normal communication)
Off Steady = No Data Transmission (auto baud in progress)
On Steady = Communication lost, waiting to join communication ring
Blink - 2 Hz
Green
FC BUS
On Steady = EOL switch in ON position
Off Steady = EOL switch in Off position
Off (Except on
terminating
devices)
Amber
EOL
Repair Information
If a controller fails to operate within its specifications,
replace the controller. For a replacement controller,
contact your Johnson Controls
®
representative.
22
FX-PCG16 General Purpose Programmable Controller Installation Instructions
