3. INITIAL
LIGHTING
If turning on the boiler for the first time carry out the following
steps:
Check that the electrical supply to the boiler is ON at the
external
isolator.
Ensure all hot taps are closed.
Set any remote controls as required.
Turn the CH control P1 to the minimum setting. Switch
on the appliance at the on/off switch on the control panel. The
boiler will then be in the STANDBY mode.
Only operate the boiler when you are sure that the system has
been correctly filled and vented. If you are in any doubt about the
boiler being filled with water contact your installer.
4. OPERATION OF THE BOILER
In order to turn on the central heating and adjust the temperature,
turn the control knob P1 to the desired setting between off and
maximum 82°C.
If the boiler is not required for an extended period turn the control
knob P1 fully anti clockwise to the off position. In this position the
frost protection will still be active.
5. RESET
FUNCTION
Should a fault occur, tuRning the central heating water
temperature control knob P1 to RESET will clear the error and
enable the boiler to relight. If the fault recurs, turn off the boiler
and consult a CORGI registered installer.
6. ERROR
CODES
Detailed on page 3 are error codes that you may encounter on
your boiler. For any sequences not illustrated, please refer to
your Installation & Maintenance Instructions or contact your local
CORGI registered installer.
7. FLAME
LOSS
Should the flame signal be lost 5 times in any 4 minute period
the boiler will lockout and an error code will be displayed on the
series of LED’s as displayed below. Turning the central heating
water temperature control (P1) to the OFF position and then back
on again, will clear the error and enable the boiler to relight
If the fault recurs, turn off the boiler and consult a CORGI
registered installer.
5
Telephone: 01604 762881
