Johnny Vac JV420HD2, User Manual

Page: 5 / 12

User Guide JV 420HD2
5
3. Operation Instructions
• TO LINK HOSE TO THE PLASTIC TANK :
Insert the end cuff hose in the machine inlet block and be sure the hose can’t
be pulled out. By pressing the inlet block’s button, the cuff can be taken out.
Note : Do not pull roughly.
• TO ASSEMBLE HOSE ACCESSORIES:
To link metal wand to hose: join straight ends of two metal wands, insert one
bended end into handle end cuff and twist it until it is well tightened. To link
brush to metal wand: Insert the other bended end into lock screw ring of floor
brush (or squeegee brush) and lock metal wand by twisting the ring. To link the
crevice tool with hose, if necessary: Insert handle end cuff into the crevice tool
(or round brush).
• TO LOCK MOBILE SQUEEGEE BRUSH:
Adjust casters on mobile squeegee brush and then fix it on the machine base
with hand screws. Finally, insert the machine end cuff and handle end cuff into
the inlet block and mobile squeegee brush respectively.
• TO ADJUST HEIGHT OF MOBILE SQUEEGEE BRUSH:
Adjust height of mobile squeegee brush with side hand screws if necessary,
according to cleaning demands.
• TO SWITCH MACHINE «ON» OR «OFF»:
When the power switch is in position « I », it is on; when it is in position « O »,
it is off. Still then, power light might still be on, meaning current is still flowing
through.
• TO START DRY SUCTION :
1. Make sure hose, metal wand and floor brush (or crevice tool, round brush)
are well installed.
2. Check if filter bag is mounted well.
3. Switch on the machine and start cleaning dry locations.
• TO START WET SUCTION :
1. Make sure hose, metal wand and squeegee brush (or mobile squeegee
brush) are well installed.
2. Take out filter bag and check if direction of the power switch is in the same
direction as the inlet block.
3. Switch on the machine and start cleaning wet locations.