48
Page
EŽƌŵĂůKƉĞƌĂƟŽŶ
KǁŶĞƌΖƐ'ƵŝĚĞ
/d/KE>&dhZ^
-
/ŶĨŽƌŵĂƟŽŶŵŽĚĞͲ
You can get some information about the water heater condition by pressing the
"INFO"
button. For more
information, follow the procedures below:
INFO
Button
Operation
Screen on the controller
Built-in controller
Remote controller
1st. press
Inlet water temperature will be
displayed on the controller by pressing
the
"INFO"
button.
Inlet water temperature
(EX.: 60 °F)
2nd. press
Outlet water temperature will be
displayed on the controller by pressing
the
"INFO"
button.
Outlet water temperature
(EX.: 120 °F)
3rd. press
And then, water flow will be displayed
on the controller by pressing the
"INFO"
button.
4th. press
Press the
"INFO"
button to finish
information mode.
Water flow
(EX.: 3.5 GPM)
-Unit conversion mode-
Units of measure can be changed from Imperial to Metric and vice versa. For example, temperature can
be changed from °F to °C. Flow rate will also change from gallons per minute to liters per minute when
this setting is changed. Follow this procedure to change this setting:
Operation
Screen on the controller
Built-in controller
Remote controller
1.
Press the
"ON/OFF"
button on the controller in
order to turn the controller on.
2.
When ON, the orange LED is lit.
3.
The previous set temperature will be displayed on
the screen.
4.
Press the
"INFO"
buttons for at least 3 seconds.
5.
The set temperature should now be displayed in the
alternate unit of measurement.
(EX.: 100 °F)
(EX.: 38 °C)
When the water heater is connected with the remote controller, the built-
in controller will not operate temperature settings. It will only work for the
information mode (Indoor models only).
NOTICE
Printed on 12/6/2017 8:34 AM CT
