01
02
Parts list Image
Qty
Introduction
Thank you for purchasing this Tony wall light.
Please read the instructions carefully before
use to ensure safe and satisfactory operation
of this product.
Warnings
This is a Class II product and must NOT be earthed.
Please read these instructions carefully before commencing any work.
This product is designed to be fixed to a wall and connected to a mains power outlet
via the supplied 3-pin plug. Do not remove the plug and connect by other means.
IMPORTANT: Children can become entangled in loose cable. Ensure excessive loops
of cable are secured against the wall using the fittings supplied. Do not use
this product in children’s bedrooms.
Recommended bulb (not included)
1 x 6W SES LED Energy Efficient Golf Ball bulb, or
1 x 28W SES Eco Halogen Golf Ball bulb, or
1 x 40W (Max.) E14 Golf
When changing a bulb, always switch off at the mains and allow the bulb to
cool before handling. Dispose of used bulbs carefully. Do not exceed the rated
power stated or use a different shape bulb from that indicated on the fitting.
Recommended bulb
Product assembly
1
Select the mains power outlet you wish to connect
the plug to and hold the product in place on the wall
ensuring it is level, mark the fixing hole positions.
Check there are no mains cables or pipes beneath
the wall. Drill the holes and fit the supplied wall plugs
(A) - which are suitable for masonry only. This product
is not suitable for use in children’s bedrooms.
Fix the product (B) to the wall using the supplied
screws (C).
To keep the cable tidy, this product is supplied with
3 cable retaining clips. Decide on the cable position.
Recommended placing is 1 clip every 50cm. Using the
retaining clips as a template mark and drill the position
of the fixing holes.
Be careful not to damage any wiring or pipes.
Place the clips around the cable and fix in place
using the supplied small screws (D).
A
Light fitting
1
Retaining clips
3
Screws
2
Small screws
3
Wall plugs
2
Small wall plugs
3
2
Fit the recommended bulb per specifications.
Plug into a mains outlet. Your wall light is now
ready to use. Switch on using the inline switch.
Note: The shade may get hot. Only adjust after
the fitting has been switched off for ten minutes.
D
B
C
