John Lewis JLWM1202, Instruction Manual

Page: 18 / 27

18
12.How to interrupt a
programme
Depress the “ Start/Pause ” button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the button again to restart the
programme.
13. How to open the door
during the cycle of a
programme
You can open the door, after having set the washing
machine to Pause, provided the following conditions
exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
If these requirements are met, when you pause the
washing machine, the door locked light goes off and the
door can be opened.
Should it not be possible to open the door, and should
it be absolutely necessary to do so, switch the machine
off by turning the selector dial to “
Off ”.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of
the water in the washing machine!
When you close the door to restart the programme
turn the dial to the previous programme repeating the
options previously selected and press START/PAUSE
button.
14. End of programme
At the end of the programme, the washing machine
stops automatically, the “
End ” light illuminates, the
“ Start/Pause ” button light goes off and the display
shows a flashing zero.
If you had selected the “ Quiet ” option, the door
locked light is on, the door is locked, the “ Rinse
Hold ” pilot light and the “ Quiet ” option light remain
lit to indicate that the water must be drained.
The display shows a flashing zero.
To drain or to spin see paragraph “ Quiet ” on page
12.
Turn the programme selector dial to Reset “ Off ” to
switch the machine off.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing
machine.