John Lewis JLTDC01, Instruction Manual

Page: 13 / 24

13
Using the tumble dryer
1
If the appliance was not transported in an upright po-
sition, leave it to stand for 12 hours before connect-
ing it to the electricity supply and using it for the first
time, so that the oil can flow back to the compres-
sor. Otherwise the compressor could be damaged.
In order to remove any residues which may have been pro-
duced during production, wipe the dryer drum with a damp
cloth or carry out a brief drying cycle (30 MINUTES) with
damp cloths in the machine.
1
If the appliance was not transported in an upright po-
sition, leave it to stand for 12 hours before connect-
ing it to the electricity supply and using it for the first
time, so that the oil can flow back to the compres-
sor. Otherwise the compressor could be damaged.
Switching machine on / switch-
ing light on
Turn the programme selector to any programme or turn it
to LIGHT. The machine has been switched on. When the
door is opened, the drum is illuminated.
Opening loading door / loading
laundry
1.
Open loading door:
Push against the loading door (push point
)
2.
Load your laundry (do not force it in/overload the ma-
chine).
1
Warning! Be careful not to trap laundry in between
the loading door and rubber seal.
3.
Close loading door securely. Lock must audibly lock.
Selecting the programme
Use the programme selector to set the programme you re-
quire.
The probable programme run time is displayed (in minutes)
on the multi-display.
Selecting additional functions
INTENSITY
For precise setting of the residual moisture content of the
laundry, the degrees of d, ++ or +++ can be set in
addition to most programmes. Laundry becomes drier from
+ to +++.
1.
Press the INTENSITY button repeatedly until the light for
the residual moisture required is lit.
In the programmes WOOL or SILK further drying can also
be set by restarting the programmes with the residual mois-
ture , ++ or +++ set in addition, as required. In the
case of a drying cycle with relatively dry laundry, the length
of the programme cycle displayed at the beginning is cor-
rected after a while.
Important : Do not over dry wool or silk.
ANTI-CREASE
If this additional function is selected, the anti-crease phase
at the end of the drying cycle is lengthened by 60 minutes.
The laundry can be removed at any time during the anti-
crease phase.
ALARM
When the drying cycle has finished, an intermittent acoustic
signal will sound.