John Lewis JLBIGGH 704 Instruction Manual Download Page 6

Page: 6 / 28

Electrical Connection

THIS HOB MUST BE EAR

THIS HOB MUST BE EARTHED

THED

THED.....

Any electrical work required to install this hob should
be carried out by a qualified electrician or competent
person, in accordance with the current regulations.

Electrical requirements

Any permanent electrical installation must comply with the
latest I.E.E. Regulations and local Electricity Board regulations.
For your own safety this should be undertaken by a qualified
electrician, e.g. your local Electricity Board, or a contractor
who is on the roll of the National Inspection Council for
Electrical Installation Contracting (NICEIC).

Electrical connections

This hob is designed to be connected to a 230 V 50 Hz AC
electrical supply.
Before switching on, make sure the electricity supply voltage is
the same as that indicated on the hob rating plate. The rating
plate is located on the bottom of the hob. A copy is attached
on the back cover of this book.
The hob is supplied with a 3 core flexible supply cable.
This has to be provided with a proper plug, able to support
the load marked on the identification plate. The plug has to
be fitted in a proper socket.
In the event of having to change the fuse, a 3amp ASTA
approved (BS 1362) fuse must be used.

Should the plug need to be replaced for any reason, the wires
in the mains lead are coloured in accordance with the
following code:
Green and Yellow

- Earth

Blue

- Neutral

Brown

- Live

— Connect the green and yellow (earth) wire to the

terminal in the plug which is marked with the letter

'E' or the earth symbol

or coloured green and

yellow.

— Connect the blue (neutral) wire to the terminal in

the plug which is marked with the letter 'N' or
coloured black.

— Connect the brown (live) wire to the terminal in

the plug which is marked with the letter 'L' or
coloured red.

Upon completion there must be no cut, or stray strands of
wire present and the cable clamp must be secure over the
outer sheath.

A cut off plug inserted into a 13 amp socket is a serious
safety (shock) hazard. Ensure that

the cut off plug is

disposed of safely.

Earth (yellow/green)

Supply cable replacement

The cable used to connect the hob to the electrical supply
must comply to the specifications given below.

Min. size Cable/flex

Min. size Cable/flex Cable / flex type

Cable / flex type

Cable / flex type Fuse

Fuse

0.75 mm

H05 V2V2-F (T90)

3 A

The manufacturer declines any liability should these

The manufacturer declines any liability should these
safety measures not be observed.

safety measures not be observed.

PPermanent connection

ermanent connection

In the case of a permanent connection, it is necessary that
you install a double pole switch between the hob and the
electricity supply (mains), with a minimum gap of 3 mm
between the switch contacts and of a type suitable for the
required load in compliance with the current electric
regulations.

The switch must not break the yellow and green

The switch must not break the yellow and green
earth cable at any point. It is necessary that

earth cable at any point. It is necessary that

earth cable at any point. It is necessary that
the yellow / green earthwire is about 2 cm

the yellow / green earthwire is about 2 cm

the yellow / green earthwire is about 2 cm
longer than the live and neutral ones.

longer than the live and neutral ones.

Ensure that the hob supply cable does not come into contact
with surfaces with temperatures higher than 50 deg. C.

Neutral