Problem
Possible cause
Solution
The lamp is defective.
Contact the nearest Authorised Serv-
ice Centre.
The compressor operates continu-
ally.
Temperature is set incorrectly.
Refer to "Operation".
Many food products were put in
at the same time.
Wait some hours and then check the
temperature again.
The room temperature is too
high.
Refer to climate class chart on the rat-
ing plate.
Food products placed in the ap-
pliance were too warm.
Allow food products to cool to room
temperature before storing.
The door is not closed correctly. Refer to "Closing the door".
The "FastFreeze" or "Intensive-
Cooling" is switched on.
Refer to "FastFreeze function" or "In-
tensiveCooling function".
The compressor does not start im-
mediately after pressing the "Fast-
Freeze" or "IntensiveCooling", or
after changing the temperature.
This is normal, no error has oc-
curred.
The compressor starts after a period
of time.
Water flows inside the refrigerator. Food products prevent the water
to flow into the water collector.
Make sure that food products do not
touch the rear plate.
The water outlet is clogged.
Clean the water outlet.
Water flows on the floor.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
Attach the melting water outlet to the
evaporative tray.
Temperature cannot be set.
The "FastFreeze function" or "In-
tensiveCooling function" is
switched on.
Switch off "FastFreeze function" or "In-
tensiveCooling function" manually, or
wait until the function resets automat-
ically to set the temperature. Refer to
"FastFreeze function" or "Intensive-
Cooling function".
dEMo appears on the display.
The appliance is in demonstration
mode.
Keep the OK pressed for approxi-
mately 10 seconds until a long sound
is heard and display shuts off for a
short time.
The temperature in the appliance is
too low/too high.
The temperature regulator is not
set correctly.
Set a higher/lower temperature.
The door is not closed correctly. Refer to "Closing the door".
Fridge Freezer User Manual
19
