Step 3
Gently pull the remaining slack cable through from the underside of the base. Gently tighten the
screw in cable grip (E). This prevents damage to the internal electrical parts in the event the cable
is strained.
Step 4
Remove the shade ring from the lampholder,
place the shade over the lampholder and
refit the shade ring. Tighten to secure the
shade in place.
Step 5
Fit the bulb per the instructions overleaf. Do
not exceed the wattage as recommended as
this may cause damage to the light fitting.
Step 6
Your standard lamp is now ready to use.
Switch on using the floor switch. (F)
A
B
C
F
D
E
Assembly
Refer to assembly drawing opposite. Carefully unpack the carton, making sure all the parts are
present before assembly. Your standard lamp has been packaged as five separate parts to prevent
damage during transit.
Thank you for purchasing this Darlington floor light. Please read the instructions carefully before
use to ensure safe and satisfactory operation of this product.
Care instructions
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as these will damage
the finish.
Warnings!
This is a Class 1I product and must not be earthed.
Please read these instructions carefully before commencing any work.
Install in accordance with the IEE Wiring regulations and the Building Regulations.
To prevent electric shock switch off at mains supply before installing or maintaining this fitting.
Ensure other persons cannot restore the electrical supply without your knowledge.
If you are in any doubt, please consult a qualified electrician.
This light fitting should be connected to a 5 amp fused circuit.
For your safety, always switch off the supply before cleaning or removing the shade.
The lit bulb must be kept 50cm away from any surface, as shown by this symbol:
0.5m
Parts list
Image
Qty
Light fitting
1
Shade
1
Shade ring
1
Step 1
Holding the tube (A) firmly, screw on tube (B). Take care not to trap the cable or cross the thread.
Then screw on tube (C) followed by tube (D). Check all joints are tight.
Step 2
Pull any excess cable through from the underside of the base. It may be necessary to loosen
screw in part (E). Turn completed assembly anticlockwise approximately 6 times (Turning the tube
anticlockwise first, ensures that the cable will straighten when tubes are fully assembled). Screw
assembly in a clockwise direction on to the base. Take care not to trap the cable or cross the
thread, firmly tighten the tube by hand.
