Getting started
Thank you for purchasing this John Lewis & Partners product. For your safety,
and to make sure everything is working properly, please read the instructions
carefully before use.
Warnings
This is a Class ll product and must NOT be earthed.
It is recommended that this fitting is installed by a qualified electrician.
Install in accordance with the IEE Wiring regulations and the Building Regulations.
To prevent electrocution switch off at mains supply before installing or maintaining this
fitting. Ensure other persons cannot restore the electrical supply without your knowledge.
If you are in any doubt, please consult a qualified electrician.
This light fitting should be connected to a 5 amp fused circuit.
If replacing an existing fitting, make a note of the connections.
This product is suitable for indoor use only.
This product is suitable for installation on surfaces with normal flammability e.g.
wood, plasterboard, masonry. It is not suitable for use on highly flammable surfaces
(e.g. polystyrene, textiles).
The product may get hot, therefore for your safety always switch off the light
and allow to cool for 10 minutes before adjusting the position.
Parts list
Description
Image
Quantity
Light fitting
x 1
Wall plugs
x 2
Screws
x 2
Product assembly
Step 1
Refer to assembly diagrams right. Carefully unpack
the carton, making sure all the parts are present
before assembly. Before removing the existing fitting,
carefully note the position of each set of wires.
Step 2
Remove the fixing bracket (A) from the product by
removing the top screws (B).
Step 4
Connect the product to the household wiring.
Check that: You have correctly identified the house wires.
The connections are tight. No loose strands have been
left out of the connection block. When completed, ensure
that there are no bare or loose strands of wire exposed.
Step 5
Re-attach the product to the fixing bracket and tighten
the top screws (B). Take care not to trap any wiring.
Adjust the head to the desired position.
Replace fuse or circuit breaker and switch on.
Your light is now ready for use.
Step 3
Using the screws provided (C) in the fixing pack,
secure the bracket (A) to the wall. Take care to avoid
damaging any concealed wiring and pipes.
A
B
C
B
