Johannus Vivaldi 150, User Manual, Page: 20 / 56

User Manual Vivaldi 150/250/350 20
Programming a capture memory location:
1. Select the desired stops.
2. Use the - and + pistons to select a level (1-75) on the display.
3. Press the SET piston. Hold in the piston.
4. Press the desired memory location (1-8).
5. Release the SET piston.
Calling up a capture memory location:
1. Use the - and + pistons to select the desired level (1-75) on the display.
2. Press the desired memory location (1-8). The active stops light up.
4.11 Transposer
The Transposer function shifts the pitch by half-tone increments (from -8 to +8).
The transposer setting can be read on the
display (
Tr: …
).
1. Press the TRANS piston.
2. Use the - and + pistons to set the pitch.
3. When the transposer change needs to be saved, press the SET piston in the
time the TRANS. piston is lit.
4.12 Crescendo pedal
The crescendo pedal can be used to activate 20 registrations step-by-step. These
registrations start with very quiet (pianissimo) to very loud (tutti).
The default registrations of the 20 steps can be changed. See § 5.2 Crescendo.
Activating the crescendo pedal
If the crescendo pedal is not activated it is
indicated on the displays with
Cr:--
.
Use the CR piston to activate the crescendo
pedal. The display indicates the actual step.
Crescendo pedal as additional swell pedal
The crescendo pedal can also be configured as a swell pedal. See § 5.6 Expression
Pedals.
If the crescendo pedal is set as additional swell pedal, all functions of the
crescendo pedal are deactivated.
Through use of the SEQ- and SEQ+ pistons previous or next memory locations can
be selected in steps of one. The lighted memory location piston and the memory
level shown in the display indicate the selected location.
The current setting of the capture memory location will be lost.
Am:Center Mem: 1
Tr: 0/440 Cr:--
Am:Center Mem: 1
Tr: 0/440 Cr: 0
Am:Center Mem: 1
Tr: 0 /440 Cr:--