Operation
Operation - 6 -
the
JOHANNUS
revolution
With the SEQ- and SEQ+ buttons you can select a lower or higher (respectively)
memory location in steps of one. The lit capture button and the display indicate which
memory location has been selected.
Transposer
The Transposer mode shifts the pitch by half-tone increments (from -8 to +8).
T
he set pitch can
be read on the display (
Trans:..
).
The pitch can only be programmed when the TRANS. button is lit.
Change
the
transposer
1.
Press the TRANS. button.
2.
Set the pitch using the - and + buttons.
The pitch shift is not stored in memory. When the organ is switched on again, the
most recently programmed pitch will be active.
Programme
the
transposer
1.
Press the TRANS. button.
2.
Set the pitch using the - and + buttons.
3.
Press the SET button.
The pitch change is stored in memory. When the organ is switched on again, the
programmed pitch will be active.
General
Crescendo
The General Crescendo pedal can be used to activate different registrations step-by-step. These
registrations start with very quiet (pianissimo) to very loud (tutti).
Activate
the
General
Crescendo
pedal
When the General Crescendo pedal has not been enabled, the display shows the message
Cresc: Off
.
1.
Press the CR button to enable the General Crescendo pedal. The display indicates
which step has been set.
Change
the
General
Crescendo
pedal
The by default set stop combinations of the crescendo steps can be changed and saved in the
memory.
Only step 0 cannot be changed.
1.
First press the CR button, then the MENU button.
2.
Use the - and + buttons to select the step to be changed.
3.
Set the required registration for the step.
4.
Press the SET button.
5.
If necessary, select another step to be changed.
6.
Press the MENU button to switch off the programming mode.
7.
Press the CR button to switch off the General Crescendo mode.
