MQ3 INPUTS AND OUTPUTS
MICROPHONE.
The microphone input is an XLR connector. All microphone impedances
and types are suitable for the JOEMEEK CurrentSense circuit.
Connections are:
Pin 1 is ground or screen.
Pin 2 is positive phase or 'hot'
Pin 3 is negative phase (or ground for unbalanced).
To avoid deafening 'clonks' try to remember to plug in capacitor
microphones before turning on the phantom power.
INSTRUMENT/ LINE INPUT - This input is a high impedance unbalanced
1/4 inch jack input suitable for any line or instrument level audio signal.
This input is for line level unbalanced signals from instruments or
equipment. It's not normally used for microphone inputs; but can be
suitable for some high output unbalanced microphones (such as battery
powered Electret types).
INSERT POINT - This is used to insert another effect or outboard
equipment into the ProChannel. The input amplifier output appears on the
tip of the 1/4 inch jack socket, the 'ring' is the return input. When no jack is
inserted, the socket is 'normalled' (internally linked).
MIX INPUT - This is an auxiliary 1/4 inch jack line input which mixes with
the normal mic or line. It can be used to add a second signal post EQ and
pre compression. Ideal for mixing an acoustic guitar with a voice.
OUTPUTS - The two output sockets are 1/4 inch jack balanced low
impedance, and are connected in parallel. The output is auto balancing and
may be unbalanced without affecting output level. One can be used as a
recording output while the other is used for monitoring/PA.
POWER - Power input is 12Volt AC only.
IMPORTANT: POWER THE MQ3 ONLY FROM THE JOEMEEK POWER
SUPPLY PROVIDED. USE OF OTHER POWER SUPPLIES WILL
DAMAGE THE MQ3 AND INVALIDATE ALL WARRANTIES.
10
MicroMeek MQ3
- User's guide
