MUTING VOLUME CONTROL CONNECTION TERMINAL
V-T4M
PREPARING FOR INSTALLATION:
The Speakers/Volume Control cables, Amplifier cables and 12V DC power
supply cable must all reach the proposed location of the V-T4M distribution hub.
Mark the cables with Wire labels, describing where the cables originate from,
rather than where they will terminate. Locate a switched AC outlet on your
Receiver or Amplifier to be used to power the V-T4M power supply.
INSTALLATION:
1. Select an appropriate location for the V-T4M
2. Run all the necessary wiring to the V-T4M. Label the wires for
future reference.
3. Strip 1/4" of insulation from the end of each wire. Tightly twist the end of
each wire until no frayed ends remain.
4. Locate the snap and lock connectors and remove them if they are plugged
in. The four-position connector plugs are for speaker wires; the two-position
connector plugs are for 12V wires.
5. Use a small flathead screwdriver or your thumb to raise the locking tabs,
exposing the holes on the connectors.
6. Insert each wire into the appropriate hole and snap down the locking tabs.
7. Insert the smooth side of the connector plug into the smooth side of the V-
T4M socket.
8. Connect the Amplifier to the connector terminal labeled: INPUT
FROM AMP.
9. Connect the Speaker wires to the connector terminals labeled: OUTPUTS
TO VOLUME CONTROLS.
10. Connect the 12V wires to the connector terminals labeled: OUTPUTS TO
MUTING RELAYS.
11. Plug the 12V DC power supply connector into the V-T4M socket
marked POWER.
V-T4M INSTALLATION DIAGRAM
V-T4M
Stereo Receiver
12V DC Power Supply
(Not Supplied) plugged into
the Switched Outlet
Speakers
Input From
Amplifier
Output to
Speakers
V-12M
JOBSITE SYSTEMS
12331 SW 130 STREET
MIAMI, FL 33186
P
866.4JB.SITE (866.452.7483)
F
305.238.0185
WWW.JOBSITESYSTEMS.COM
©2004 Niles Audio Corporation. JobSite,
Pure Custom and Niles are registered
trademarks of Niles Audio Corporation
and the JobSite Logo is a trademark of
Niles Audio Corporation. JSVT4MPDF
Specifications subject to change without notice.
Summary of Contents for V-T4M
Page 4: ......
