HIGH OUTPUT IR EMITTER
IR-E1HO
PREPARING FOR INSTALLATION:
The IR-E1HO is typically used as a “flooding” emitter to control a stack of
audio/video components. For this type of application, place the IR-E1HO with its
LED’s pointed straight up and at least an inch in front of the equipment you
wish to control. For tall stacks of components use multiple IR-E1HO emitters.
Make sure the mounting surface is cleaned and degreased before installation.
INSTALLATION:
1. Test the operation of the IR-E1HO in the planned mounting location. If all of
the components operate correctly via the IR repeater system, proceed.
2. Make sure the mounting surface is clean.
3. Remove the protective coating from the self-adhesive tape and attach the
IR-E1HO to the mounting surface.
4. Route the connecting two-conductor wire to the IR Connecting Block and
plug it into an Emitter output.
5. Coil any excess wire and tie it in place.
6. On IR Connecting Blocks with selectable Emitter outputs make certain the
HI-LOW SWITCH is placed in the HI position.
IR-E1HO INSTALLATION DIAGRAM
12V DC Power
Supply
(Not Supplied)
plugged into
the Switched
Outlet
12V DC Power Supply
Plugged into an Unswitched
AC Outlet Powers the System
IR-CB-2
JobSite
IR-E1HO
Emitter
IR-E1HO
12VDC/
OUTPUT
HI
LOW
HI
LOW
1
1
2
2
3
5
4
EMITTER OUTPUTS
POWER
+12V DC
IR RECEIVER INPUTS
3-30V
AC/DC
STATUS
IN
IR-CB2
IR CONNECTING BLOCK
IR-SMR
Stereo
Receiver
CD
DSS
JOBSITE SYSTEMS
12331 SW 130 STREET
MIAMI, FL 33186
P
866.4JB.SITE (866.452.7483)
F
305.238.0185
WWW.JOBSITESYSTEMS.COM
©2004 Niles Audio Corporation. JobSite,
Pure Custom and Niles are registered
trademarks of Niles Audio Corporation
and the JobSite Logo is a trademark of
Niles Audio Corporation. JSIRE1HOPDF
Specifications subject to change without notice.
Summary of Contents for IR-E1HO
Page 4: ......
