jobmate JMPGB150G, Safety And Operating Manual, Page: 7 / 12

7
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book
carefully.
INTENDED USE
The machine is intended for cutting grooves for biscuit dowel
joints in chipboard, hard and softwood, plywood, fibreboard.
1. ASSEMBLY INSTRUCTIONS
Before use, the eye shields/spark arresters must be fitted
to the grinder.
Remove both eye shields from packaging, position the shields
over the two mounting brackets above the grinding wheels
with the flanges of the spark arrester facing away from you,
fix with the screw and washer provided. At this stage do not
fully tighten. (See Fig.A)
The next step is to adjust the eye shields/spark arresters. To
do this move the eye shields/spark arresters so as to obtain
a gap as small as possible between the arrester and the
grinder wheel, not greater than 2mm, the screw must now
be fully tightened, (See Fig.B). The gap must be maintained as
the wheel wears.
2. WORK REST ADJUSTMENT
Take the work rest out of the package, fix on the grinder with
the knob and washer provided as shown in Fig.C. The gap
between the rests and the wheels should be checked before
use. Measure the gap between the grinding wheel and the
rests; this should be as small as possible not greater than
2 mm, if not, loosen the knobs on each of the rests, set the
correct gap and fully tighten.
( See Fig.D ). The gap must be
maintained as the wheel wears.
3. OPERATING
Make sure grinder is securely mounted; mounting holes are
provided in the base of the grinder for this purpose, but the
screws are not provided. Plug in the mains supply and push
the on/off switch right to the on position. Switch off and
unplug the grinder when not in use.
Fig.A
Fig.B
Fig.C
Fig.D
Fig.E