jobmate JMBMS210G, Safety And Operating Manual

Page: 8 / 16

8
THE SUPPORT STAND (SEE FIG. C1,C2)
Pull the support stand to its extreme, as shown in Fig. C1,C2
WARNING: Always keep the support stand at its
extreme out position when using the product.
3. WORK CLAMP (SEE FIG. D)
1) The work clamp can be fitted on either side of the saw and
is fully adjustable to suit the size of the workpiece.
2) Do not operate the saw without clamping the workpiece.
3) Make sure that the work clamp securing screws are
tightened.
4. MOUNTING HOLES (SEE FIG. E)
Before use, the saw can be fixed to a firm, level surface with
the 4 mounting bolts (not supplied).
Four holes are provided in the base of the saw to enable it to
be fixed to a bench, or other supporting surface.
To mount the saw, proceed as follows:
1) Locate and mark where the saw is to be mounted.
2) Drill 4 holes through the surface.
3) Place the sliding miter saw on the surface aligning holes
in base with holes drilled in the surface. Install bolts, washers
and hex nuts.
16
17
17
a
19
2
1
1
2
2
18
Fig.A
Fig.B1
Fig.B2
Fig.C1
Fig.E
Fig.D
Fig.C2
Fig.G
Fig.F2
Fig.F1