Operating under the theory that an ounce of prevention is worth a pound of headaches.
Note that this installation guide is only a guideline. Each boat is different and improvisation is needed to mount your Addict Tower Bimini.
We advise you to have your Bimini mounted by a professional who has experience in boatconstructions and mounting towers and Biminis.
Read and understand all of the information contained in this operator’s manual before assembling and using this product.
Contents of Box
Prior to assembly, make sure all the required parts are present.
The (size M) Bimini top
The (size L) Bimini top
147cm-wide top for boat decks measuring 78” to 93”/203cm to 238 cm
187cm-wide top for boat decks measuring 94” to 108”/238cm to 275cm
Step 1. Start by placing the rubber ring on the front bar of the tower about 80cm from the top. Place the clamp (A) over the rubber ring as in drawing. do not tighten
the screws at this point as the clamp need to be adjusted later on.
Note: Keep the screw-thread facing toward the inside of the boat.
Step 2. Now place the other rubber ring and clamp in the other front bar of the tower in a mirrored way.
Step 3. Place the two center bars (C) on one of the side frames (B). Slide the front and center of the canopy sleeves over the center bars which you have just installed.
Step 4. Attache the other side frame to the partially assembled frame.
Step 5. Now attache the frame to the tower clamp (A) (with two persons). When folding the bimini frame backwards, it should rest on the tower top. If not you need to
adjust the clamps so it will aline with the top bar.Tighten the clamps when position perfect.
Step 6. Fold the main frame (B) to the front and the smaller bar (C) to the back (see drawing) and attache the canopy back on the topbar of the tower.
First use the two zippers and than the the velcro in the corners
Note: The front of the bimini always should be lower than the back. (see dawing)
Step 7. Attach the nylon straps on the frame and determine where the eye pads (E) should be placed. !Keep the strap free from any obstructions! Cover the area where
the eye pads (E) will be placed with masking tape. Mark the spot to drill the holes. Before drilling inspect underneath these locations for obstructions such as wires or
cables, also check the accessibility. You are now ready to drill the holes. For this use the drill bit size 4mm. After drilling the holes, you can remove the masking tape,
it is recommended to chamfer the holes using the chamfer drill bit, this to prevent the gelcoat from cracking.
Fine tuning the bimini
You may need to make the center bar bigger or smaller if the canopy is not fitted properly.
You can make an angle in the canopy to get tension on the canopy
Tighten all hardware for completion of bimini installation.
THE TOP SHOULD NOT BE USED WHEN VESSEL SPEED EXCEEDS 35MPH/56KPH
Care and Maintenance
I.
Be sure to check and tighten all fasteners and connections prior to every use.
II.
Be cautious when driving under obstacles, low hanging structures or trees with your bimini on.
III.
Use soap and water or general cleaners to clean your bimini. Avoid abrasive materials that might scratch the bimini’s finish.
IV.
Always rinse bimini after contact with salt (brackish) water.
JOBE Addict Bimini Warranty
Jobe Sports International warrants this product (not including other 3rd party accessories) against manufacturers defects. Anodizing and powder coated surfaces as well
as all hardware corrosion are specifically excluded as their care and use cannot be controlled by Jobe Sports International. Any modifications or improper use shall void
this warranty. Jobe Sports International is not responsible for personal injury or damage to the boat caused by the use of this tower. JOBE’s obligation under this war-
ranty shall not include any transportation charges or costs of installation or any liability for direct, indirect or consequential damages resulting from delay or improper
installation. No dealer, retailer or manufacturer is the agent of Jobe Sports International and may not assume for Jobe Sports International any liability in connection
with this warranty. This warranty is in lieu of all.
Distributed by:
Jobe Sports International
Heerewaardensestraat 30, 6624 KK Heerewaarden
The Netherlands
WWW.JOBESPORTS.COM
center bars
canopy
cover
side frame
stainless steel
pad eye
bimini clamp
strap
80cm
80cm
80cm
