11
12
co
tto
n/
lin
en
si
lk/w
ool synthetic
s
MIN
co
tto
n/
lin
en
si
lk/w
ool synthetic
s
MIN
cotton
/lin
en
sil
k/w
oo
l s
ynth
etics
M
IN
The plastic parts can be cleaned with a
damp cloth then wiped over with a dry cloth.
Self-Cleaning
The Self-Cleaning
(N)
feature cleans inside the
plate, removing impurities. We recommend
using it every 10-15 days. Directions:
1.
Fill the tank up to the Maximum Level
(O)
and set the Steam Selector
(D)
to “0FF”.
2.
Place the iron in the vertical position.
3.
Turn the Temperature Control Dial
(G)
to
the Max position.
4.
Plug the iron into the mains power and
allow to heat for 2 mintues.
5.
Unplug the iron, remove from the base
and place it horizontal over a sink or
basin.
6.
Press the Self-Cleaning Button
(N)
repeatedly for around one minute to
activate the cleaning function. This will
release both steam and water through
the soleplate to clear any deposits.
Repeat above steps again if needed,
particulary in hard water areas.
[Fig. 9]
Caution: When using the Self-Clean
function hot water and steam will rush
through the solepate.
Dry ironing
To iron without steam, simply turn the Steam
Selector
(D)
to the ‘OFF’ position.
Spray Function
Make sure that there is water in the tank.
Press the Spray Button
(E)
slowly (for a
dense spray) or quickly (for a vaporized
spray).
[Fig. 8]
Warning: for delicate fabrics, we
recommend moistening the fabric
beforehand using the Spray Button (E),
or putting a damp cloth between the
iron and the fabric. To avoid staining,
do not use the spray on silk or synthetic
fabrics.
Fig. 8
Fig. 9
Fig. 10
Using Phoenix Gold
®
FreeFlight
continued
Using Phoenix Gold
®
FreeFlight
continued
E
D
Cleaning
Note: before cleaning the iron in any
way, make sure that it is unplugged
from the electrical supply.
Any deposits left on the plate can be
removed using a damp cloth or a non-
abrasive liquid detergent.
Avoid scratching the plate with steel wool or
metallic objects.
7.
Place the iron in the vertical position
and allow to cool. This will enable any
residual water to dry.
8.
After completing the Self-Cleaning
cycle, turn the iron on again at the
mains and allow to heat for two minutes
to dry out any residual water inside the
steam chamber.
9.
Run the soleplate over an old piece of
cloth to clean it of any impurities.
10.
When the soleplate has cooled down,
you can clean it with a damp cloth.
When using again, allow the iron to
heat fully and activate the steam setting
again, ironing on a old piece of cloth to
get any remaining impurities that may
have settled around the steam vents.
How to put it away
1.
Disconnect the plug of the iron from the
socket.
2.
Empty the tank by turning the iron
upside down and gently shaking it.
3.
Leave the iron to cool down completely.
4.
Wind the power cord around the base.
Do not overpull the cord as this may
weaken the anchor point.
[Fig. 10]
5.
Always put the iron away in a vertical
position.
N
Summary of Contents for Phoenix Gold FreeFlight
Page 1: ......
