Assembly
1. Plug the Telescopic rod (
2
) into the recess on the top of the Motor unit (
4
).
2. Place the Hanger (
1
) onto the Telescopic rod (
2
). When you do this, make sure that
the slight bend in the Hanger (
1
) points forwards.
3. Attach the Nylon balloon:
–
Pull it over the Hanger (
1
). When you do this, make sure that the side with the hole
line points forwards.
–
Pull the Small elastic cord at the top over the collar section (
9
) on the Hanger (
1
).
–
Pull the Large lastic cord at the bottom over the Mounting flange (
7
).
The device is disassembled in the reverse order.
Use
CAUTION!
■
Only place the device on a stable, flat, moisture-resistant and heat-resistant surface.
■
Caution! Hot surface! The motor unit / telescopic rod will become hot during use. You
should therefore not touch it during or shortly after use.
■
It is essential that you follow the care labels for the textiles to be dried!
■
Never cover up the ventilation slots and do not insert any objects into them.
1. Set the height you want. To do this, open the clip (
8
), pull
out the telescopic rod (
2
) and then close the clip (
8
) again.
2. If you have not already done so, pull on the Nylon balloon
(see the “Before Initial Use” chapter, “Assembly” section).
The Nylon balloon should sit immediately below the
Mounting flange (
7
) so that it can fully inflate.
