P/N 960-100190RA_Rev. A {EDP #148851}
© 2009, Japan CashMachine Co., Limited
4 - 1
S e c t i o n 4
This section provides disassembly and reassembly
instructions for the Banknote Recycler. This sec-
tion contains the following information:
•
Tool Requirements
•
Main CPU Board Removal
•
Drive Motor Removal
•
Open/Close Detection Board Removal
•
Encoder & Position Detection Board Removal
•
Rubber Pulley/Drive Roller Removal
•
Clear & Metallic Edge Belt Removal
•
Clear & Metallic Edge Belt Replacement
Tool Requirements
The following tools will be required to perform
disassembly and reassembly:
•
A #1 & #2 Phillips Screwdriver
•
Set of Jewelers Phillips Screwdrivers
•
E-Clip (E-Ring) Pliers
•
Needle Nose Pliers
•
Tweezers
Main CPU Board Removal
To remove the Main CPU Board proceed as
follows:
1. Use a Jewelers Screwdriver to release the
two (2) Claw Hooks located on the upper
side of the Front Cover (See Figure 4-1 a
1
&
a
2
), and remove the Front Cover from the
VEGA-RC Unit (See Figure 4-1 b).
2. Remove four (4) mounting screws
1
, a
2
, a
3
, & a
4
) retaining the
Main CPU Board (See Figure 4-2 b) to the
Unit.
3. Pull the CPU Circuit Board slightly outward
at its top, and then slide it to the right in
order to clear the Pushbuttons from the left
side of the chassis. The CPU Circuit Board is
now only connected to the Unit by two (2)
Connectors located in the lower left corner
of the Board.
4. Carefully unplug the two (2) Connectors
from the CPU Board (See Figure 4-2 c
1
&
c
2
).
Drive Motor Removal
To remove the Drive Motor proceed as follows:
1. Remove the four (4) Cabinet mounting
screws (See Figure 4-3 a
1
, a
2
, a
3
, & a
4
)
located on each side of the Unit using a #2
Screwdriver, and remove the Right Side
Cover (R) (See Figure 4-3 b); then
2. Remove the Left Side Cover (L) (See Figure
4-3 c) from the Unit.
4 DISASSEMBLY/REASSEMBLY
Figure 4-1
Front Cover Removal
a
1
b
a
2
Figure 4-2
Mian PC Board Removal
b
a
1
a
2
a
3
a
4
c
1
c
2
NOTE: If the CPU Board is being
replaced with a new Board, be sure to
remove the Display Protection Sticker
located on the Seven (7) Segment
Display of the new CPU Board before
installing it.
