7
4.9
TO PREVENT BURNING OR FIRE
1.
The fixture can be mounted directly on the surface of ordinary combustible material.
2.
Do not short-circuit temperature protection switch or fuse, use the specified type of fuse.
3.
The equipment must be installed away from inflammable and explosive materials.
4.
The equipment should be projected range of 10 meters away objects and projectiles
temperature less than 60 ° C 10m
5.
Fan or ventilation, at least in the range of 0.5 meters can not be an obstacle.
6.
Do not place any object on the lens.
7.
Handling at least allow the device to cool for 20 minutes.
8.
Do not replace the non-original parts.
5.
PACKING AND SHIPPING
5.1
ACCESSORIES PROJECT
.NEX260 packed with fly-case of two in one ,or carton box. Attach follow accessory.
ACCESSORY
CONTENT
QUANTITY
USER MANUL
1
SAFETY ROPE
1
HANG FIXTURE
2
SIGNAL CABLE
1
5.2
TRANSPORT PROTECT LOCK
In order to protect the light, there is a protect lock; During the transport , the lock catch
position need lock in the center, and the fixture keep in vertical state.
5.3
ABOUT PACKING
1. Before packed, make sure power is off, and wait for at least 20mins for cooling down.
2. Before clean the fixture, make sure X, Y axis protect lock closed.
3. After packed by plastic bag, high-lift the fixture with two handles besides the product. put
the product into the fly-case up-side-down.
4. After packed the product, put the accessory into the accessory case, then closed and lock the
fly-case.
5. Fly-case only up stacked two layers. Prohibited upside down
6. When packed with carton box, equipment should be put into the foam first, then set into a
carton, pay attention to the vertical position.
5.4
UNPACKING
Note: Before unpacking check the damage is whether due to the transportation or not, if you find any
such damage, please do not use this item, and contact with the dealer or manufacturer as soon as
possible.
1. Open the fly-case, and discover the inside plastic bag.2. High-lift the product by two
handles beside the bottom base and move it out.3. Before power on, make sure you have opened
the X, Y axis lock!
10
