81900511 Rev. B
©2019 JMA Wireless. All rights reserved. This document contains proprietary information. All products, company names, brands, and logos are trademarks™ or
registered® trademarks of their respective holders. All specifications are subject to change without notice. Revised: July 8, 2019
+1 315.431.7100 [email protected]
Installation Guide
Stadium Mounting Bracket - Rotational
Instructions for Mounting Kit 91900324
6
7
Venue bracket details (Figure 4):
Bracket 1 can be re-oriented 90° to support vertical mounting
configurations. Keep the word “top” on the antenna facing top, and the
weep hole facing down. Use Screw 6 for locking bracket into specific
angle positions. Torque to 30 lbf∙in (3.39 N∙m). Use the holes in Bracket
2 (4.50” [114.3 mm] apart @ CL) and 3/8” hardware for wall mounts.
Figure 4: Bracket kit details
Note:
•
Parts 2-10 can be rotated 90° if needed, to rotate the antenna. For
example, Bracket 1 has two mounting positions on pre-installed
Bracket 45700440-01.
•
When rotating the antenna, additional weep holes must be drilled
to properly drain antenna. Refer to JMA weep hole modification
guide at jmawireless.com
Other key details:
The brackets were designed to handle pole diameters ranging from
2.5 to 4.5 inches.
All 10-32 hardware to be torqued to 30 lbf∙in (3.39 N∙m).
All 3/8” hardware to be torqued to 20 lbf∙ft (27.12 N∙m).
All 1/4” hardware to be torqued to 75 lbf∙in (8.47 N∙m).
Fasteners / hose clamps for wall mount and pole mount not
included in 91900324 bracket kit. (Sold separately)