JLL VENTUS 1, Instruction Manual

Page: 7 / 12

6
#52 d8 2PCS
#1 M8*20*S6 2PCS
#2 d8* 16*1.5 2PCS
S6 #B
1
52
2
79
81
71
79
1
2
1
52
2
S6 S5
#A
#B
67
66
65
64
79
63
51
2
1
#67 10*100*105 1PC
#64 10*95*M6*25 1PC
#66 M6*16*S5 1PC
#65 d10* 20*2 1PC
63
51
49
67
STEP 4:
Attach the Sliding Rail (No. 79) to the Main
Frame (No. 49) using one Sleeve Bolt (No.
64) , one Washer (No. 65) and one Small
Screw (No. 66) . Tighten and secure with the
Large Allen Wrench (#A) and the Standard
Allen Wrench (#B) .
Lift the Sliding Rail (No. 79) where it
connects to the Main Frame (No. 49) to align
the holes. Then insert the Pull Pin (No. 67) .
Finally, connect the Trunk Wire 1 (No. 51) to
the Sensor Wire (No.63) .
STEP 3:
Slide the Seat (No. 71) onto the Sliding Rail
(No. 79) .
Attach the Rear Stabilizer (No. 81) to the
Sliding Rail (No. 79) using 2 Medium Bolts
(No. 1) , 2 Spring Washers (No. 52) and 2
Washers (No. 2) . Tighten and secure with the
Standard Allen Wrench (#B) .