SECTION 4 - MACHINE OPERATION
3121636
– JLG Lift –
4-27
THE USE OF ROPES, CHAINS OR SLINGS WITH LENGTH LESS THAN 10 ft.
(3m) COULD CAUSE PERMANENT DAMAGE TO THE MACHINE OUTRIG-
GERS.
As the weight of the machine is not spread equally over the
four outriggers, the minimum required capacity of the four
ropes, chains or slings used must be: no less than 4,409 lb.
(2000 kg) and their length no less than 10 ft. (3m) and all
identical.
Lifting - Fork Lift Pockets
The machine is equipped with two tubular fork lift pockets
designed to lift the machine using a forklift of suitable
capacity.
1.
Determine gross weight of machine, refer to the
serial number tag, or weigh the individual unit to
find out the gross vehicle weight.
2.
Configure the machine in the transport position;
a.
place the booms in the stowed position and
properly aligned
b.
all outriggers are fully retracted
c.
tracks are fully widened
d.
Remove all loose items from the machine
3.
Adjust forks of fork lift to the proper width for the
lifting pockets on machine.
4.
Carefully approach the machine with fork lift truck
being careful not to damage any machine compo-
nents. Insert the forks into the lifting pockets on
the machine and carefully lift machine.
5.
Move machine to new location.
Figure 4-7. Lifting Machine - Lifting Rings Location
1.
Lifting Rings (4 - 1 Each Outrigger)
1
1
To
order
go
to
Discount-Equipment.com