SECTION 4 - MACHINE OPERATION
4-8
3121783
Jib Position for Traveling
It is necessary to raise the JIB arm when driving up or down
slopes that exceed 10° and but less than the max. 15° to pre-
vent the jib from contacting the ground.
ONLY PERFORM THIS OPERATION WHEN IT IS NECESSARY. IN ALL OTHER SIT-
UATIONS, DRIVE WITH THE BOOM AND JIB FULLY LOWERED AND ALIGNED.
Permission to use the JIB is indicated by the
icon in position 5 on the remote control
display panel.
Before lifting the jib arm in the traversing
phase, the following conditions must be
verified:
•
All outriggers must be lifted from the ground.
•
There must be no operator in the platform.
NOTE:
The aerial part safety device by-pass key must not
have been activated after the machine has been
closed and aligned.
If any of these conditions have not been met, the use of the
JIB is not possible and one of the following error displays
appears.
After these conditions have been met, make sure that there
are no obstacles in the Jib working area and operate as fol-
lows:
•
Activate joystick for moving the JIB arm. If a different
joystick is activated an error message will appear on the
display.
•
After slope has been passed, for which the jib had to be
raised, fully lower jib and continue traveling.
•
With JIB raised, ALWAYS travel at minimum speed and
keep JIB as near as possible to the ground.
OL00160
OL00170
OL00180
To
order
go
to
Discount-Equipment.com
