SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3121744
JLG Lift –
3-9
3.8
PLATFORM MANUAL DESCENT CONTROL
The platform manual descent control is used in the event of
total power failure to lower the platform using gravity. The man-
ual descent control T-handle is located on the left rear of the
machine, just below the platform ladder. Look for the instruc-
tion decal located beside the release handle.
The lowering procedure is as follows:
1.
Locate the
manual descent control T-handle
.
(See Figure 3-4.)
KEEP HANDS AND ARMS OUT OF THE PATH OF THE SCISSOR ARMS AND PLAT-
FORM WHILE LOWERING.
2.
Grasp the T-handle and slowly pull out to lower the
scissor arms/platform, when the platform is lowered
to desired level, allow the T-handle to return to it’s
closed position.
Figure 3-4. Location of Manual Descent Control
(Left Rear of Machine)
Summary of Contents for 1532R
Page 2: ...NOTES...
Page 62: ...SECTION 4 EMERGENCY PROCEDURES 4 4 JLG Lift 3121744 NOTES...
Page 96: ......
Page 97: ......