TWEETER INSTALLATION:
The dome tweeters supplied with your
XR650-CSi system have been designed for
maximum mounting versatility. There are two
primary methods by which the tweeters can be
mounted in your vehicle:
1)
Flush Mounted, using the supplied flush-mount
cup and hardware.This application will yield a
custom-installed appearance, but will require at least
3/4-inch (19 mm) of clearance behind the mounting
surface of the tweeter.
2)
Surface Mounted, using the supplied surface
mount kit and hardware. In this application, you will
not need to cut holes in your vehicle’s panels for
the tweeters.You will only need to drill a hole for
the wires and for the two mounting screws.This
application is useful when mounting the tweeters to
a panel that has insufficient clearance behind it for
the tweeter’s magnet structure.
Run speaker wires from the tweeter output of
the crossover to the desired tweeter mounting
locations, observing the same precautions as
mentioned in the woofer installation section.
Terminate the wires with the supplied 2.8 mm male
crimpable connectors.
Swivel/Rotation Mechanism:
Once the tweeter has been mounted into the
flush mount cup as shown above, it can be swiveled
and rotated by hand to best enhance imaging using
the swivel/rotation mechanism built into the flush
mount system. Experiment with different angles
until you arrive at the best solution. The
swivel/rotation feature will not operate with the
surface mount system.
JL AUDIO
XR650-CSi
7
1a
1b
1c
1d
1e
2
Assemble the Flush-Mount Cup
Mounting Hole Diameter: 1.75 in. (45 mm)
Attach the Tweeter to the Swivel Assembly
Insert the tweeter
and swivel asembly
into the mounted
flush-mount cup,
feeding the wires
through the slots
in the rear of the cup.
Line up the arms of
the swivel assembly
with the slots on the
inside of the flush
mount cup
Tighten
Screw
Vehicle
Panel
Use two thin metal objects as shown to release
the tweeter element from the flush-mount cup.
