Continued on Next Page
SB-VW-JETNCS/10W1v2 INSTR_SKU# 011332
Page 3 • JL Audio, Inc., 2011
S T E P 1 5
Secure the Bracket with a pair of 1/4 - 20 x 1” Bolts through
the holes drilled in the previous step.
S T E P 1 9
Thread a 3/8 - 16 x 2-1/4” Set Screw into the U-Nut as shown.
S T E P 1 4
Using a 1/4” drill bit, drill, drill the two mounting holes as
indicated on the Template Sticker.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a reduction
in your weekly pay.
Always wear eye protection when drilling!
S T E P 1 8
Slide a U-Nut over the hole in the Bracket as shown.
S T E P 1 3
Align the Template Sticker over the two holes, and affix the
sticker.
S T E P 1 7
Thread a 1/4 - 20 KEPS Nut onto the back of the lower 1/4 -
20 x 1” Bolt and firmly tighten. Remove the shop rag from
the cavity.
S T E P 1 2
Locate the two holes at the rear of the trunk near the taillight.
S T E P 1 6
Thread a 1/4 - 20 KEPS Nut onto the back of the upper 1/4
- 20 x 1” Bolt and firmly tighten. We recommend stuffing
a shop rag down the cavity to prevent losing the nut if
dropped.
