➔
➔
➔
STEP 7:
Place the carpet that was pulled out of
the corner in
STEP 2
, back into position.
Cut out an access hole in the carpet, that is lined up
and position above the black metal plate’s hole, from
STEP 6
.
STEP 8B:
When the knob is unlocked correctly,
the exposed knob will pull away from the side panel,
but is still attached to the cleat assembly.
With the cleat unlocked, remove from the side
panel.
Cont.
From
Previous
Page
Continued on Next Page
➔
➔
STEP 8:
Remove the access door(
A
) and cargo
net cleat(
B
).
Follow
STEPS 8A
and
8B
to properly remove
the cargo net cleat.
STEP 9:
Run the speaker wire to the Stealthbox’s
location.
Check for proper operation of the woofer and
attach speaker wire to terminal.
Before placing the Stealthbox back into location,
back out the threaded rod to expose about 1”.
STEP 8A:
This is how the cleat looks when
installed into the side panel. (side panel not seen)
Grab a hold of the exposed knob’s edge with your
finger nails and pull out. It should not require a lot of
force.
*Do not force it.*
S B - T- 4 R N R 2 / 1 0 W v 2 , J L AU D I O, I n c 2 0 0 3
S h e e t S K U # 0 1 1 1 8 1 R ev i s i o n 0 1 / 1 3 / 2 0 0 4
Pa g e 2
w w w . j l a u d i o . c o m
➔
STEP 10:
With the Stealthbox wired up and in
location(with socket cup set screw placed through the car-
pet, metal plate and floor).
Place a supplied flat washer onto the supplied bolt. Place the
bolt assembly through the upper mounting support bracket
of the Stealthbox and the factory plastic side panel.
On the back side of the plastic side panel, place a supplied
flat washer, lock washer and then thread supplied nut onto
the bolt assembly .(through the removed excess door loca-
tion.)
Using a 9/16” open end wrench to hold the nut behind the
plastic panel.Tighten the exposed bolt with a 9/16” socket.
A
B
➔
